Preview

Proceedings of the Voronezh State University of Engineering Technologies

Advanced search

Mathematical modeling of snacks drying process from minced fish in a fluidized bed

https://doi.org/10.20914/2310-1202-2022-2-17-26

Abstract

A mathematical model of snacks drying process from minced fish in a fluidized bed with distributed parameters of the heat exchange process between the surface of an anisotropic body and the environment is proposed. The solution of the problem of non-stationary heat transfer by heat conduction using the Galerkin method is considered. The trial and verification functions of the method used, implemented in the PTC MathCAD engineering calculation environment, are linearly independent, represent the first elements of a complete system of polynomial functions and satisfy the boundary and initial conditions. Theoretical and experimental studies have been carried out, which allow considering the process of drying snacks from minced fish in a fluidized bed and scientifically substantiate options for its improvement. According to the results of experimental studies, the adequacy of the obtained mathematical model is shown. It is proved that with a uniform initial temperature distribution during preheating, the temperature inhomogeneity increases up to the moment of a phase transition on the surface of dried object. The importance of taking into account the preheating phase of wet material is established, since at this stage a temperature profile is formed, which is characterized by significant heterogeneity. This is especially important, since temperature heterogeneity directly affects the quality of the food product. The possibility of taking into account anisotropy in heat transfer processes using a three-dimensional mathematical model of transport with distributed parameters is confirmed. The developed technique allows significantly increasing the accuracy of an anisotropic boundary value problem solving by replacing the operation of integrating the stiffness matrix elements with a system of differential equations by algebraic formulas.

About the Authors

V. S. Kosachev
Kuban State Technological University

Dr. Sci. (Engin.), professor, technological equipment and life-support systems department, 350072, Krasnodar Krai, Krasnodar, Moskovskaya str., 2,



A. N. Ostrikov
Voronezh State University of Engineering Technologies

Dr. Sci. (Engin..), professor, technologies of fats, processes and devices of chemical and food production, department, Revolution Av., 19 Voronezh, 394036, Russia,



A. А. Yashonkov
Kerch State Maritime Technological University

Cand. Sci. (Engin.), machines and apparatuses of food production, department, 298309, Republic of Crimea, Kerch, Ordzhonikidze str. 82



References

1. Ustinova M.E., Yashonkov A.A. Experimental studies into the kinetics of the process of vacuum drying of carrot chips. IOP Conf. Series: Earth and Environmental Science. 2019. vol. 640.

2. Gukasyan A.V., Koshevoy E.P., Kosachev V.S. Two-dimensional mathematical model of oil-bearing materials in extrusion-type transportation over rectangular screw core. Journal of Physics: Conference Series. 2018. vol. 1015.

3. Koshevoy E.P., Kosachev B.C., Meretukov Z.A. Theoretical consideration of the deformation of the material at the exit of the extruder. News of higher educational institutions. Food technology. 2004. No. 5–6. pp. 86–88. (in Russian).

4. Podgorny S.A., Koshevoy E.P., Kosachev V.S. Thermodynamic approach in the theory of drying // News of higher educational institutions. Food technology. 2015. no. 4. pp. 88–91. (in Russian).

5. Netto J.D.P.C., Oliveira Filho P.R.C.D., Lapa-Guimarães J., Viegas E.M.M. Physicochemical and sensory characteristics of snack made with minced Nile tilapia. Food Science and Technology. 2014. vol. 34. pp. 591-596. doi: 10.1590/1678-457x.6395

6. Wang Y., Zhang M., Mujumdar A.S., Mothibe K.J. Quality changes of dehydrated restructured fish product from silver carp (Hypophthalmichthys molitrix) as affected by drying methods. Food and bioprocess technology. 2013. vol. 6. no. 7. pp. 1664-1680. doi: 10.1007/s11947-012-0812-y

7. Dementieva N.V., Boitsova T.M., Bogdanov V.D. A study of combined minced meat from hydrobionts for snacks. Czech Journal of Food Sciences. 2021. vol. 39. no. 2. pp. 140-148. doi: 10.17221/264/2020-CJFS

8. Pokholchenko V., Smirnova A. Energy efficient systems and regimes at fish products drying processes. IOP Conference Series: Earth and Environmental Science. IOP Publishing, 2019. vol. 302. no. 1. pp. 012027.

9. Nawaz A., Khalifa I., Walayat N., Lorenzo J.M. et al. Whole fish powder snacks: Evaluation of structural, textural, pasting, and water distribution properties. Sustainability. 2021. vol. 13. no. 11. pp. 6010. doi: 10.3390/su13116010

10. Nawaz A., Xiong Z., Li Q., Xiong H. et al. Evaluation of physicochemical, textural and sensory quality characteristics of red fish meat‐based fried snacks. Journal of the Science of Food and Agriculture. 2019. vol. 99. no. 13. pp. 5771-5777.

11. Ganesan P., Rathnakumar K., Nicy B.A., Vijayarahavan V. Improvement of nutritional value of extruded snack product by incorporation of blanched dried fish powder from sardine and Lizard fish and selection by organoleptic evaluation. Journal of Entomology and Zoology Studies. 2017. vol. 5. no. 6. pp. 2552-2554.

12. Yean Y.S., Pruthiarenun R., Doe P., Motohiro T. et al. Dried and smoked fish products. Fish Drying & Smoking. Routledge, 2017. pp. 47-87.

13. Wang Y., Zhang M., Mujumdar A. S. Effect of cassava starch gel, fish gel and mixed gels and thermal treatment on structure development and various quality parameters in microwave vacuum-dried gel slices. Food Hydrocolloids. 2013. vol. 33. no. 1. pp. 26-37. doi: 10.1016/j.foodhyd.2013.02.005

14. Kamari S., Shabanpour B. Development and sensory evaluation of silver carp (Hypophthalmichthys molitrix) fish based snack food. World Journal of Fish and Marine. 2013. vol. 5. no. 6. pp. 670-673.

15. Ponwiboon N., Rojanakorn T. Desorption isotherms and drying characteristics of Nile tilapia fish sheet. International Food Research Journal. 2017. vol. 24. no. 3. pp. 1292.

16. Yashonkov A., Sukmnov V. Experimental determination of the rational parameters in the process of foaming and drying of raw fish. Food and Packaging. pp. 55.

17. Shaviklo G.R., Thorkelsson G., Sveinsdottir K., Pourreza F. Studies on processing, consumer survey and storage stability of a ready-to-reconstitute fish cutlet mix. Journal of food science and technology. 2013. vol. 50. no. 5. pp. 900-908. doi: 10.1007/s13197-011-0417-x

18. Stepanov D.V., Gukasyan A.V., Kosachev V.S., Oleynikova R.E. Solution of the Burgers Shock wave equation in PTC MATHCAD. Procedia computer science International Conference on Computational Intelligence and Data Science, ICCIDS 2019. 2020. pp. 1088–1095.

19. Kouhila M., Moussaoui H., Lamsyehe H., Tagnamas Z. et al. Drying characteristics and kinetics solar drying of Mediterranean mussel (mytilus galloprovincilis) type under forced convection. Renewable Energy. 2020. vol. 147. pp. 833-844. doi: 10.1016/j.renene.2019.09.055

20. Ospanov A., Muslimov N., Timurbekova A., Mamayeva L. et al. The effect of various dosages of poly-cereal raw materials on the drying speed and quality of cooked pasta during storage. Current Research in Nutrition and Food Science. 2020. vol. 18(2). pp. 462–470. doi: 10.12944/CRNFSJ.8.2.11

21. Zuev A.V. On periodic solutions of ordinary differential equations with a discontinuous right-hand side. Mathematical notes. 2006. vol. 79. no. 4. pp. 560–570. (in Russian).

22. Dvoryaninova O.P., Sokolov A.V. Simulation of the drying process of secondary products of fish cutting and description in the model of the main processes of heat and moisture transfer. Proceedings of VSUET. 2018. vol. 80. no. 2. pp. 125–129. doi: 10.20914/2310-1202-2018-2-125-129 (in Russian).


Review

For citations:


Kosachev V.S., Ostrikov A.N., Yashonkov A.А. Mathematical modeling of snacks drying process from minced fish in a fluidized bed. Proceedings of the Voronezh State University of Engineering Technologies. 2022;84(2):17-26. (In Russ.) https://doi.org/10.20914/2310-1202-2022-2-17-26

Views: 520


Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 License.


ISSN 2226-910X (Print)
ISSN 2310-1202 (Online)